PRODUCTION

Examples of finished MOULDS


	Mould for the MOTOR VEHICLE SECTOR Mould-holder material 1.2311 Cavity blocks and carriages 1.2344 HRC 52/54 Hot channel feed Injected material PA 6.6 GF 30

	Mould for the MOTOR VEHICLE SECTOR Mould-holder material 1.2311 Cavity blocks 1.2344 hardened at 50/52 HRC Carriages 1.2343 hardened at 50/52 HRC Mould with 5 movements of which 1 hydraulic in the fixed part Feed: cold channel and injected material tunnel: ABS


Mould for the BATHROOM FURNISHING SECTOR Figures obtained from tempered steel 1.2311 Feed: cold channel tunnel Injected material: polypropylene

Mould for the BATHROOM FURNISHING SECTOR Figures obtained from tempered steel 1.2311 Feed: cold channel tunnel Injected material: polypropylene


	Part for the BATHROOM FURNISHING SECTOR "JET NOZZLE" Part obtained from mould with 2 figures Moulded material: POM acetal resin

"SOFT BRUSH" Part obtained from mould with 8 cavities Feed: cold channel and tunnel Moulded material: Soft PVC

	Part for the ELECTRICAL SECTOR Obtained from mould with 4 cavities Feed: cold channel and tunnel Moulded material: Self-extinguishing ABS

Part for the
MOTOR VEHICLE SECTOR

Obtained from a mould with 1 cavity
Feed: cold channel and tunnel
Moulded material: PA 6 GF 30

	Part for the MECHANICAL SECTOR Obtained from mould with 2 cavities Feed: hot channel 2 injectors in the figure Material: POM acetal resin

Part for the
FURNISHING SECTOR

Obtained from moulds with 4 figures each
Feed: cold channel and tunnel
Moulded material: PA6 GF 15

	Mirror part for the FURNISHING SECTOR Obtained from 4 moulds Feed: cold channel and tunnel Moulded material: PP POM and PA6 with graphite

Part for the
DOMESTIC APPLIANCE SECTOR

Mould with 1 cavity
Feed: cold channel and tunnel
Moulded material: PP

	Part for the DOMESTIC APPLIANCE SECTOR Composed of 2 pieces obtained from 2 moulds with 1 cavity Feed: hot injector directly in the figure Material: ABS